Bass Clone
Analog chorus pedal for bass guitar, built on the circuit of the Small Clone with a crossover switch that keeps low end out of the modulated signal. Suited to bassists who want chorus without losing note definition.
- Analog chorus based on the Small Clone circuit
- X-Over switch cuts lows from the modulated signal
- Bass knob affects only the dry half of the signal
- Treble knob affects the whole mixed signal
- True bypass with red status LED
- Runs on included 9V battery or optional 9.6VDC adapter
Foto’s
7Advertenties
Nog geen advertenties van dit model
Als iemand een Bass Clone verkoopt, zie je hier de advertenties en de verkoopgeschiedenis.
Verkoop er zelf eenBeschrijving
The Bass Clone is a compact analog chorus whose core circuit is nearly identical to the Small Clone. Chorus is made by mixing a modulated signal with the dry signal, and this pedal adds controls aimed at bass guitar so the low end stays tight.
A crossover switch removes low frequencies from the modulated half of the signal, which keeps the bottom end articulate and the notes well defined. Depth sets the amount of modulation and Rate sets its speed. Treble boosts or cuts the highs of the whole mixed signal, while Bass boosts or cuts the lows of the dry half only. Used together with the crossover switch, these allow a focused bass tone with a chorus shimmer on top.
The pedal uses true bypass switching, with a red LED showing when the effect is on. It has a mono input and an amp output on ¼" jacks, is housed in a die-cast case, and runs from the included 9V battery or an optional 9.6VDC-200mA adapter sold separately.
Video
Specificaties
- Merk
- Electro-Harmonix
- Model
- Bass Clone
- Categorie
- Effecten en pedalen
Audio
- Circuit
- Analog
- Audio
- Mono
- Bypass
- True Bypass
- Effect type
- Bass chorus
Controls
- Depth
- Controls the amount of modulation
- Rate
- Controls the speed of modulation
- Bass
- Boosts or cuts low end from the dry half of the effect signal
- Treble
- Boosts or cuts high end from the mixed effect signal
- X-Over switch
- Cuts low end from the modulated half of the signal when facing up
- Footswitch
- Toggles effect on and true bypass
- Status LED
- Red, lit when the effect is engaged
Connectivity
- Input jack
- ¼"
- Amp (output) jack
- ¼"
Power
- Power supply
- 9V battery included (optional 9.6VDC-200mA power adapter not included)
- Current draw
- 15mA
Physical
- Dimensions (in)
- 4.5 x 2.75 x 2.1
- Construction
- Die-cast, compact
In the box
- Battery
- 9V battery included